Honeywell LYNX User Manual

– 63 –
SYSTEM FUNCTIONS
Testing the System (to be conducted weekly)
Test Mode
The Test mode allows each protection point to be checked for proper operation. When the
Walk Test mode is active, the control sounds a single beep every 30 seconds as a reminder
that the system is in the Test mode.
NOTE: An alarm message will not be sent to your alarm monitoring company during these tests.
Entering Test Mode
Disarm the system and close all protected windows, doors, etc. The “READY” indicator
should be lit.
Testing the System
Arm Away
Ready To Arm
Arm Stay
BackDelay
Settings
10:18 AM June 8, 2010
5000-100-007-V0
Tools
1. With the system in the disarmed state,
select the “Tools” icon from the second page
of the Home Screen. The system displays
the Keypad screen.
Ready To Arm
Program the system
Enter Code:
Cancel
5000-100-009-V0
231
5
64
0
8
97
Clear
2. Enter your 4-digit Master User Code. The
system displays the Master User
programming screen.
Slide ShowDate Time
Ready To Arm
Events
Back
Reminders
TestSchedulesDevicesUsers
5000-100-070-V0
3. Select the “Test” icon. The system displays
the Test screen.

Honeywell LYNX Specifications

General

Voice Control	No
Type	Wireless Security System
Voice Prompts	Yes
Display	Color touchscreen
Communication	Cellular
Automation	Z-Wave
Battery Backup	Yes
Series	LYNX Touch
Compatibility	Honeywell Total Connect
Power Supply	Plug-in transformer
Keypad	Integrated touchscreen
Remote Control	Via Honeywell Total Connect app