– 25 –
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
Disarming the System
Select the “Disarm” icon or the “Off” key to disarm the system and to silence alarm and
trouble sounds. See the SUMMARY OF AUDIBLE NOTIFICATION section for information,
which will help you to distinguish between fire and burglary alarm sounds. During Entry
Delay or when an Alarm Condition exists, the system will be disarmed as soon as the correct
user code is entered on the touchscreen. Selecting the OFF key is not required. The entry
beeps or alarm sound can be silenced by pressing any key however, it will restart in 10
seconds if the correct User Code is not entered. The READY indicator will light (if no alarms
have occurred while armed) and the control will beep once to confirm that the system is
disarmed.
**IMPORTANT**
If the LYNX Touch is beeping rapidly upon entering the premises, an alarm has occurred
during your absence and an intruder may still be on the premises. LEAVE IMMEDIATELY
and CONTACT THE POLICE from a nearby safe location.
Disarming the system and silencing alarms
Armed: Stay
More
10:18 AM June 8, 2010
5000-100-056-V0
Zones
Message
System
Disarm
Phone
1. Select the “Disarm” icon or depress the
“Off” key. The system will beep once and
display a keypad.
Armed Stay
Enter Code:
Cancel
231
564
0
897
Clear
5000-100-065-V0
2. Enter a valid Code. The system will beep
once and announce
“Disarmed Ready to
Arm”
.
Note: If a valid user code is not entered or the
Confirm icon has not been selected
within 30 seconds, the system will return
to the “home” screen and it will not be
disarmed.
If an invalid User Code is entered, system will return to the home screen.
To Next Page
Loading...
Need help?
General
