Honeywell Lyric W1 - Maintenance and Troubleshooting; Reset; Status LED

7
Reset
To reset the Wi-Fi, detector settings and to re-start the Bluetooth
pairing use one end of a paperclip to press and hold into the reset
hole for 5 seconds. The LED will blink blue.
Press and hold the paperclip into the reset hole for 15 seconds to
restore factory defaults. The LED will blink blue.
Status LED
The detector has an LED that gives device status.
LED Detector state
During installation
Blinking blue Powering up and connecting to Bluetooth.
Solid blue Paired with Bluetooth.
Blinking green Connecting to Wi-Fi network.
Solid green Has power, Wi-Fi connection, and is operating
normally.
Note: LED switches o after 5 minutes to
preserve battery life.
Solid red Failed to connect to Wi-Fi.
During operation
Blinking red Detected a leak.
32325307_A.indd 7 3/7/2017 4:41:31 PM