Honeywell 5800CO - User Manual

To Next Page

How to Remove and Reposition a Honeywell Carbon Monoxide Sensor Model 5800CO

Description

This page shows how to remove and reposition a Honeywell Carbon Monoxide Sensor Model

5800CO

Please read through the directions in its entirety before commencing.

Preparation

***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the

panel on test mode through myadt.ca. After logging in:

1. Tap [Home]

2. Tap [Place on Test]

3. Enter your expiration date and time

4. Enter your password

5. Tap [Yes-Proceed]

Parts Required

1. A Phillips screwdriver

2. A thin sharp knife

Other manuals for Honeywell 5800CO

Need help?

Do you have a question about the Honeywell 5800CO and is the answer not in the manual?

Steps to prepare the system before sensor removal or repositioning, including placing the panel on test mode.

List of necessary tools, including a Phillips screwdriver and a thin sharp knife, for the task.

Detailed instructions for safely detaching the carbon monoxide sensor from its mounting plate.

Guidance on selecting a new location and securing the carbon monoxide sensor in place.

Steps to prepare the system before sensor removal or repositioning, including placing the panel on test mode.

List of necessary tools, including a Phillips screwdriver and a thin sharp knife, for the task.

Detailed instructions for safely detaching the carbon monoxide sensor from its mounting plate.

Guidance on selecting a new location and securing the carbon monoxide sensor in place.

General