Do you have a question about the Honeywell 5898 and is the answer not in the manual?
Perform Go/No Go tests to verify signal strength before permanent mounting.
Enroll the sensor's ID in the system during the initial walk test mode.
Optimize sensor enrollment and verify detection signals.
Adjust microwave range and observe LED for desired detection range.
Identifies trouble conditions like self-test failures and provides resolution steps.
Perform Go/No Go tests to verify signal strength before permanent mounting.
Enroll the sensor's ID in the system during the initial walk test mode.
Optimize sensor enrollment and verify detection signals.
Adjust microwave range and observe LED for desired detection range.
Identifies trouble conditions like self-test failures and provides resolution steps.
| Field of View | 90° |
|---|---|
| RF Frequency | 345 MHz |
| Supervisory Interval | 60 minutes |
| Detection Range | 40 ft (12.2m) |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Operating Humidity | 5% to 95% (non-condensing) |
| Battery Life | Up to 5 years |
| Range | 200 ft (open air) |
| Compatibility | Honeywell Wireless Alarm Systems |
| Battery Type | 3V Lithium Battery (e.g., Duracell DL123A or Panasonic CR123A) |












Loading...