Honeywell Lyric - Security Functions; Security Features Overview

11
Security
Home > Security
IMPORTANT
If the Controller is beeping rapidly when you enter the premises, an alarm has
occurred and an intruder may still be nearby.
LEAVE IMMEDIATELY and CONTACT THE POLICE from a safe location.
Security Features
NOTES • For Lyric™ to report alarms over the internet, your Wi-Fi® network MUST have power
at all times.
• You must arm your security system in order for it to sound alarms.
Sensors and
Zones
Lyric’s sensors are assigned to numbered
zones
that correspond to areas of your
home. For example, the sensor on an entry/exit door might be assigned to Zone 03,
a device in a bedroom to Zone 06, and so on.
When alarms or trouble conditions occur, the touchscreen displays the zone number
and a description of the sensor involved.
Fire
Protection
Fire protection is always active when the system is operating normally. An alarm
sounds if a fire condition is detected. See
Fire/CO Alarm System
for important
information about fire protection, smoke detectors and planning emergency exit
routes.
Carbon
Monoxide
Carbon monoxide (CO) detectors, if installed, are always active and sound an alarm if a
carbon monoxide condition is detected. See
Fire/CO Alarm System
for more
information.
Burglary
Protection
Lyric provides STAY and AWAY burglary protection.
STAY
mode protects windows and exterior doors, allowing you to move around
inside your home without setting off an alarm.
AWAY
mode protects the entire premises, including interior motion detectors if
present.
Both modes offer an entry delay period that allows you to reenter the home without
setting off an alarm. For long periods such as vacations, the entry delay can be
turned off while arming the system.
Lyric also allows you to
Bypass
selected sensors before arming the system.
The system also features
Chime
mode, which can alert you to the opening of
protected doors and windows while the system is not armed.
Security
Codes
At the time of installation, the installer asks the homeowner to choose a personal
4-digit security code, known as the “Master User code”.
Other users can be added, typically with less control over the system than the Master
User. See
Users and Security Codes
.
A user code is required when arming or disarming and for some other functions.
Alarms Alarms are signaled by the Controller’s internal sounder (and external sirens if connected).
The screen indicates the zone where the alarm has occurred. After 15 seconds, the
sounder stops temporarily and the system begins voice announcements of relevant
zone information.
After the zones are announced, the panel’s sounder resumes sounding. Alarm sounds
and voice announcements alternate until the system is disarmed or until alarm bell
timeout occurs. If the system is connected to central monitoring, an alarm message
is sent.
To silence the sounder, disarm the system. The zone(s) causing the alarm remain
displayed, indicating Memory Of Alarm. See
Clearing a Panic Alarm
for more about
clearing memory of alarm.
Audio Alarm
Verification
Allows your central monitoring station to listen to or talk with persons on the
premises.
Keypad
Lockout
If 24 numeric keys (0-9) are entered within a period of 15 minutes and no valid command is
executed, Lyric will not process any further numeric key-presses for the following 15
minutes. Entering any numerical keys during that period causes the panel to sound a single
long beep. When the 15-minute lockout period is over, a
Restore
message is sent to the
Central Station and recorded in the Event Log.