61
Event Log Codes
The Lyric™ Controller’s Event Log can record and display as many as 6000 system events. Events
are stored locally in the Controller, in chronological order and sent to your monitoring company as
needed. When the maximum number of stored events is reached, the oldest 2000 entries are
deleted to make room for logging new events.
The type of events that can be recorded is selectable; refer to the Lyric Controller Installation and
Reference Guide’s Programming section. The Events and codes displayed vary with your system’s
options. The table below provides definitions of the events/codes that may be transmitted to the
Central Station and/or displayed by the controller.
Note: If the Controller’s backup battery is exhausted after AC power is lost, any system activity
occurring after the Low Battery notification is
not saved. Additionally, the Controller appears to have
the same status condition as it did before the low battery notification.
110 Alarm, Fire Fire
121 Alarm, Duress Duress
122 Alarm, Silent Silent
123 Alarm, Audible Audible
131 Alarm, Perimeter Perimeter
132 Alarm, Interior Interior
134 Alarm, Entry/Exit Entry/Exit
135 Alarm, Day/Night Day Night
137 Alarm, Tamper Tamper
145 Expansion Module Tamper Expansion Module Tamper
146 Silent Burglary Silent Burglary
150 24-Hour Non-Burglary 24 Hour Non-Burglary
162 Carbon Monoxide Detected Carbon Monoxide Detected
301 Trouble, AC Loss AC Loss
302 Trouble, Low System Battery Low system battery
305 Trouble, System Reset System Reset
308 System shutdown System shutdown
316 System Tamper* System Tamper
341 Trouble, Case Tamper Cover Tamper
344 Trouble, RF Receiver Jam Detect RF Jam Detect
350 Long Range Radio Reset Long Range Radio Reset
353 Trouble, Long Range Radio Transmitter Fault Comm. Trouble
354 Failure to Communicate Event Failure to Communicate Event
373 Trouble, Fire Trouble Fire trouble
374 Trouble, Exit Error Alarm Exit error alarm
380 Trouble, Sensor Sensor trouble
381 Trouble, Loss of Supervision RF Superv Loss-RF
383 Trouble, Sensor Tamper Sensor Tamper