Honeywell NOTIFIER AM1000 - Page 14

Page 10 Programming manual AM-1000
NOTIFIER ITALIA Doc. M-145.2-AM1000-ENG Rev A.1 AM1000_manu
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
I
I
N
N
G
G
M
M
E
E
N
N
Ù
Ù
Pressing the function key F1 it is possible to gain access to the programming menù, that allow the possibility
to perform the initial configuration of the system ant to make any changes in the programming.
To access to the menù it is necessary to insert the Level 4 password (default password: 44444).
To insert the password look up the editing function described on a pag. 5.
The following menù is visualized:
 System Menù
Thanks to the sub menù “System” it is possible to depict some general parameters effective for the
complete control panel, see the following plate:
Where :
•
•
L
L
i
i
n
n
e
e
Style : (4 = NORMAL, 6 = LOOP)
This function allow to change (in memory) the type of line connection, in accordance with the NFPA coding
(NORMAL = style 4 , LOOP = style 6) and the priority scan connected.