Honeywell Notifier AFP-100

To Next Page

Intelligent Control Panel

SLC

Wiring Manual

Document 51253 Rev: U5

12/20/2017 ECN: 17-0433

Main Page

Table of Contents5
Section 1: Introduction8
About this Manual8
UL 864 Compliance8
1: Products Subject to AHJ Approval8
Reference Documentation9
SLC Overview11
Polling Protocols11
1: Available Protocols11
2: Protocol Use12
Devices12
1: Monitor/Zone Interface Module12
2: Control Modules12
3: Isolator Modules12
4: Relay Modules13
5: Multiple Input/Output Modules13
6: Transponders13
7: Plug-In Detector Bases13
8: Intelligent Detectors13
9: Addressable Manual Pull Stations14
10: Wireless Interface14
11: ACPS-610 Addressable Charger/Power Supply14
12: ACPS-2406 Addressable Charger/Power Supply14
13: AMPS-24 Addressable Power Supply14
SLC Capacity15
SLC Performance15
LED Operation15
Section 2: Wiring Requirements16
Recommended SLC Wiring16
Two-Wire SLC - Style 4 (Class B)17
1: Measuring Loop Resistance17
2: Measuring Total Wire Length18
Four-Wire SLC Style 6 & 7 (Class A)18
1: Measuring Loop Resistance18
2: Measuring Total Wire Length19
Control Panel Terminal Blocks19
1: NFS2-3030 and NFS-3030 with LCM-320, LEM-32019
2: NFS2-640 with Loop Expander Modules, NFS-320 and NFS-320SYS20
3: NFS-640 with Loop Expander Modules20
4: Afp-10020
5: Afp-20020
6: Afp-300/Afp-40021
7: AM2020/AFP1010 with LIB-200A or LIB-40021
8: System 5000 with AIM-20021
Section 3: Shielded Wire Termination22
Overview22
No Conduit22
Full Conduit22
Partial Conduit23
Floating Shield23
Section 4: SLC Circuits Without Isolators24
Overview24
NFPA Style 4 SLC24
NFPA Style 6 SLC25
Section 5: SLC Circuits with Isolators26
Overview26
Fault Isolator Modules26
Isolator Detector Bases27
1: How an Isolator Base Works27
NFPA Style 4 SLC Using Isolator Modules29
NFPA Style 6 SLC Using Isolator Modules31
NFPA Style 7 SLC Using an Isolating Device32
Section 6: Monitor Modules33
Description33
1: Addressable Monitor Module33
2: Zone Interface Module33
3: Miniature Monitor Module34
4: FMM-4-20 4-20Ma Monitor Module34
Setting an SLC Address for a Module35
NFPA Style B IDC Using Monitor Modules35
NFPA Style D IDC Using Monitor Modules36
NFPA Style B IDC Using Zone Interface Modules37
NFPA Style D IDC Using Zone Interface Modules38
Section 7: Control Modules40
Description40
1: Setting an SLC Address40
Wiring a NAC with Addressable Control Modules40
1: Wiring a Solenoid with the FCM-1-REL41
Wiring a Style y NAC (Two-Wire) with Addressable Control Modules41
Wiring a Style Z NAC (Four-Wire) with Addressable Control Modules42
Connecting a Releasing Device to the Addressable Control Module43
Section 8: Relay Module44
Description44
1: Setting an SLC Address44
Wiring the Addressable Relay Module (Form-C Relay)44
Section 9: Multiple Input/Output Modules45
Description45
1: Fdm-145
2: Fdrm-145
Setting the SLC Address45
Wiring the Dual Monitor Module45
Wiring the Addressable Dual Monitor/Dual Relay Module46
NFPA Style B IDC Wiring Using Dual Monitor Modules46
Section 10: Intelligent Detectors, Intelligent Detector Bases, and Wireless Gateway48
Description48
1: Intelligent Detector Bases48
2: Intelligent Aspiration Detectors48
3: Wireless Gateway48
Wiring a Detector Base49
Wiring an Isolator Base51
Wiring a Relay Base51
Wiring a Sounder Base52
Wiring and Programming Aspiration Detectors52
Wiring the FWSG54
1: SLC Connections54
Power Connections: Powered by the SLC55
1: Power Connections: External, Regulated +24 VDC Power Source56
Section 11: Addressable Manual Pull Station57
Description57
1: Setting an SLC Address57
Wiring a Manual Pull Station57
Appendix A: Power Considerations58
A.1: Supplying Power to 24 VDC Detectors and Nacs58
A.2: Supervising 24 VDC Power58
A.2.1: Using Type Codes with Built-In Power Supervision on the NFS2-3030, NFS-3030, NFS2-640, NFS-320 and NFS-320SYS58
A.2.2: Power Supervision Relay58
A.2.3: Using the Addressable Control Module Without Relay60
Appendix B: SLC Surge Suppression62
B.1: Introduction62
B.2: Installation62
B.2.1: Afp-100 & Afp-20063
B.2.2: Afp-300, Afp-40063
B.2.3: AM2020 & AFP1010(LIB-200A or LIB-400)64
B.2.4: NFS2-3030, NFS-3030, NFS2-640, NFS-640, NFS-320, and NFS-320SYS65
Appendix C: Terminal Conversion Charts for V-Type and H-Type Devices67
C.1: Frm-167
C.2: FCM-1 and FZM-168
C.3: Fmm-168
C.4: Ftm-168
C.5: Fdm-169
Appendix D: Intelligent Detector Base Layouts for Legacy Devices70
D.1: Wiring a Detector Base70
D.2: Wiring an Isolator Base71
D.3: Wiring a Relay Base71
D.4: Wiring a Sounder Base72
Appendix E: Canadian Versions of SLC Devices73
Index76

Model	AFP-100
Type	Fire Alarm Control Panel
Operating Temperature	32°F to 120°F (0°C to 49°C)
Battery Backup	24 VDC, 7 Ah
NAC Circuits	2
Humidity Range	10% to 93% Relative Humidity, Noncondensing

Honeywell Notifier AFP-100 - User Manual

Table of Contents

Honeywell Notifier AFP-100 Specifications

Related product manuals