NCA-2 Manual — P/N 52482:M5 03/20/2019 35
LCD-160, LCD-80, LCD2-80 and NCA-2 Installation
3.19 LCD-160, LCD-80, LCD2-80 and NCA-2
LCD-160 - The NCA-2 connects to the LCD-160 via the two RDP pins on TB9: T IN+ and T IN-. If it is the last device on the RDP bus,
the LCD-160’s end-of-line resistor must be enabled. Refer to the LCD-160 manual for connection information.
LCD-80 - The NCA-2 connects to the LCD-80 at TB9, using all four pins. Refer to the LCD-80 manual for connection information.
LCD2-80 - The NCA-2 connects to the LCD2-80 at TB2, using all four pins. Refer to the LCD2-80 manual for connection information.
To Next Page
Loading...
Need help?
General
