62 NCA-2 Manual — P/N 52482:M5 03/20/2019
Programming Alter Status Menu
The advanced test provides more information for the operator by allowing him/her to track the activation of a single input point/zone to
the set of points that responded to the activation across the portion of the networked points specified at the start of testing. The operator
will be allowed to set activation and response times to be included for each set of points.
5.3.7 Change Time/Date
Select the CHANGE TIME/DATE option from the alter status menu to access this feature. This allows you to change the system time
and date. The current time and date will be displayed using the selected format. Use the keypad to enter the numeric values for the fol-
lowing fields: Hour, A.M. or P.M. (A or P), Minute, Month, and Year. The system automatically displays the day of the week regardless
of format.
• The TIME FORMAT soft key will toggle between the following format choices:
HH:MM AM/PM
H:MM AM/PM
HH:MM
H:MM
Note: The H:MM format will replace leading zeros in the hour with a space character.
• The DATE FORMAT soft key will toggle between US (MM/DD/YY) and European (DD/MM/YY) format.
• The TIME ZONE soft key toggles between 34 time zone selections. The selection of time zone also has an inherent selection for
whether daylight saving is in effect and the switch-over time. For example, USA EASTERN and INDIANA EAST are the same
time zone, except INDIANA EAST does not change times with the Daylight Saving Time (DST) changes in the spring and fall.
• The ACCEPT key will implement the changes shown.
• The BACK soft key will return to the Alter Status Menu screen without making any changes.
Figure 5.14 Change Time/Date
5.3.8 Control On/Off
Control On/Off enables you to control a point on a remote node. It is for use across a network only; not for use with display nodes such
as the NCA-2, NCS, etc.
Press the POINT SELECT soft key to scroll through device types. The NEXT SELECTION/PREVIOUS SELECTION soft keys will
increment to the next/previous Node number or device on the loop. When you have selected the desired device type, enter the device
address, then press the ACCEPT soft key to accept the entry or <ESC> to exit. The soft key BACK will also exit without saving. After
selecting the point, the NCA-2 will display it and give the following options: FORCE ON and FORCE OFF. If the point is currently on,
the FORCE ON option is not visible, letting the user know the current setting of that point.
TROUBLE
PROG MODE ACTIVATED
NODE LABEL FOR LOCAL NCA-2
10:48:52A TUE JAN 22, 2019 N009
CHANGE TIME/DATE
TIME/DATE: 11:22A 01/22/19
TIME FORMAT : HH:MM AM/PM
DATE FORMAT : MM/DD/YY ACCEPT
TIME ZONE : USA EASTERN BACK
Main menu
Program/alter status menu
Alter status menu
Change time/date
NOTE: Control on/off is for use across a network only.
To Next Page
Loading...
Need help?
General
