Honeywell RAEGuard 2 PID - Page 3

RAEGuard 2 PID User’s Guide
2
Language .......................................................................... 27
Set Span Value ................................................................. 27
Meas. Gas* ....................................................................... 27
Ext. Alarm Delay* ............................................................ 27
Pump Duty (%)* ............................................................... 27
Calibration Type* ............................................................. 27
Pump Cycle(s)* ................................................................ 27
Calibration Gas* ............................................................... 27
Pump Status* .................................................................... 27
Bus Baudrate .................................................................... 27
Analogout 4mA ................................................................ 27
Analogout 20mA ................................................................ 27
Unit ID .............................................................................. 27
LCD Contrast .................................................................... 27
LCD Backlight .................................................................. 27
Change Password* ............................................................ 27
9.1 Entering Programming Mode .............................. 28
9.2 Calibration ........................................................... 29
9.3 Measurement (Advanced Mode) ......................... 32
9.4 Alarm Setting ....................................................... 35
9.5 Monitor Setup ...................................................... 37
10 Calibration .................................................................. 43
10.1 Zero Calibration ................................................... 44
10.2 Span Calibration .................................................. 46
11 Alarm Signal Summary .............................................. 48
12 Maintenance ............................................................... 50
13 DigiPID Sensor Module Replacement ....................... 50
14 Troubleshooting .......................................................... 52
SECTION 2: DigiPID User’s Guide
SAFETY INSTRUCTIONS ..................................................... 54
15 Read Before Operating ............................................... 55
15.1 DigiPID Marking ................................................. 56
15.2 Operation Area and Conditions ........................... 57
15.2.1 Hazardous Areas classified by Zones ............ 57
15.2.2 Hazardous Areas classified by Divisions ...... 57