Disconnect wires and remove the old wallplate only after all wires are labeled. Wrap the wires around a pencil to
prevent them from falling though the wall opening.
Mount New Wallplate
1. Loosen the locking screw at the bottom of the thermostat. Note that the screw is captive and cannot be
removed from the wallplate.
2. Separate the thermostat from the wallplate as per Figure 1.
3. Position the wallplate against the wall and mark hole positions with a pencil.|
NOTE: Levelling is for esthetics only and will not affect the performance of the thermostat.
4. Drill holes at the marked positions and insert supplied wall anchors.
5. Pass the wires through the large opening located at the bottom center of the wallplate as per Figure 2.
6. Secure the wallplate to the wall with supplied mounting screws as per Figure 3.
7. Connect the wires to the terminals.
Connect Wires (typical wiring)
1. Match each labeled wire with the terminal having the same letter.
To Next Page
Loading...
