1. Install 2 AAA batteries on the back of the thermostat.
2. Align the two brackets on the top of the thermostat with the corresponding slots on the top of the wallplate.
3. Push the thermostat against the wallplate.
4. Tighten the screw at the bottom of the thermostat.
5. Turn power back on at the heating/cooling system.
Advanced Installation
system setup
Follow the procedure below to personalize and con-figure the thermostat according to the heating/cooling system.
1. Press and hold the s and t buttons simultaneously (for three seconds) until the display appears as shown below.
2. Press the s or t button to change the option.
3. Press the s and t buttons simultaneously for one second to advance to the next function.
4. When the last function is displayed, press the s and t buttons to save any changes and exit the menu.
To Next Page
Loading...
