Need help?Do you have a question about the Honeywell RTH7400 series and is the answer not in the manual?
General| Display Type | Digital |
|---|---|
| Programmable | Yes |
| Program Periods Per Day | 4 |
| Wi-Fi Connectivity | No |
| Programmability | 7-Day |
| Voltage | 24V |
| Backlight | Yes |
| Power Source | Battery |
| Battery | AA |
| Temperature Range | 40°F - 90°F |
Lists key features like easy programming, one-touch control, precise comfort, filter reminder, and large display.
Press to adjust temperature or make selections from screen menus.
Press to select fan operation or system mode.
Press to set or adjust the program schedule.
Press to set clock or access furnace filter reminder.
Displays the current day of the week.
Displays the current indoor temperature reading.
Displays the current time.
Shows the target temperature setting.
Indicates the active system mode (e.g., Heat, Cool, Auto).
Indicates the active fan mode (e.g., On, Auto).
Explains various status messages like 'Cool On' or 'Heat On'.
Instructions to press CLOCK and use arrow buttons to adjust the current time.
Press DONE to save changes or GO BACK to exit without saving.
Press SYSTEM & FAN, then FAN to select the desired fan operation.
Details for 'On' (always on) and 'Auto' (runs with system) fan modes.
Press SYSTEM & FAN, then SYSTEM to select the system mode.
Descriptions for Heat, Cool, Auto, Off, and Em Heat system modes.
Press SCHEDULE, then EDIT to begin adjusting program schedules.
Use SELECT DAY to choose specific days or day groups for settings.
Use arrow buttons to set the Wake time for selected days.
Use arrow buttons to set the Heat temperature for the period.
Use arrow buttons to set the Cool temperature for the period.
Program LEAVE, RETURN, and SLEEP periods by repeating steps.
Repeat steps to program Saturday/Sunday schedules.
Press DONE to save all programmed schedule settings.
Press SCHEDULE, then EDIT to begin adjusting program schedules.
Use SELECT DAY to choose multiple days for common settings.
Use arrow buttons to set the Wake time for selected days.
Use arrow buttons to set the Heat temperature for the period.
Use arrow buttons to set the Cool temperature for the period.
Program LEAVE, RETURN, and SLEEP periods.
Repeat steps to program any unassigned days.
Press DONE to save all programmed schedule settings.
Press arrow buttons to adjust temperature, overriding the current schedule temporarily.
Press USE SCHEDULE to cancel temporary setting and resume the programmed schedule.
Adjust temperature and press HOLD to maintain it 24 hours a day.
Press USE SCHEDULE to cancel 'Hold' and resume the program schedule.
CAUTION: Do not use Auto Changeover if outdoor temperature drops below 50°F (10°C).
Press RESET after changing the filter to restart the reminder timer.
Manually adjust the filter reminder interval before it expires.
Allows thermostat to learn time needed to reach programmed temperature settings.
Forces compressor to wait before restarting to prevent equipment damage.
Feature for dual-climate use; caution about low outdoor temperatures.
Instructions on how to grasp and pull the thermostat to remove it from the wallplate.
Guidance on installing two fresh AA alkaline batteries for backup power.
Steps to troubleshoot a blank thermostat display, checking power and connections.
Troubleshooting for when key presses don't work or temperature doesn't change.
Steps to resolve issues where the heating or cooling system does not respond.
To Next Page