Honeywell S7999D SOLA - Page 46

65-0315—02 46
Heat
exchanger
high limit
enable
Enabled
Disabled
22 21
Heat
exchanger
high limit
setpoint
-40 °F to 266 °F
(-40 °C to 130 °C)
Heat
exchanger
high limit
response
Recycle & delay
Recycle & delay with retry limit
Lockout
Heat
exchanger
retry limit
0 to 100
Heat
exchanger
high limit
delay
___hour ___min ___sec
CH anticon-
densation
enable
Enabled
Disabled
23 22
CH anticon-
densation
pump
Normal (no change)
CH pump forced off
CH anticon-
densation
setpoint
-40 °F to 266 °F
(-40 °C to 130 °C)
DHW anti-
condensa-
tion enable
Enabled
Disabled
DHW anti-
condensa-
tion pump
Normal (no change)
DHW pump forced off
DHW anti-
condensa-
tion setpoint
-40 °F to 266 °F
(-40 °C to 130 °C)
Anticondensa
tion Priority
Anticondensation is more
important than (check those
that apply):
Stack limit
Delta T limit
Slow start
Forced rate
Outlet high limit
Table 60. Configurable Parameters. (Continued)
Parameter Comment
Table
#
Page
#
CH frost
protection
enable
Enabled
Disabled
24 22
DHW frost
protection
enable
Enabled
Disabled
Lead Lag
frost
protection
enable
Enabled
Disabled
Outdoor frost
protection
setpoint
-40 °F to 266 °F
(-40 °C to 130 °C)
(applicable for CH only)
Lead Lag
frost
protection
rate
___%
CH pump
frost overrun
time
___hour ___min ___sec
DHW pump
frost overrun
time
___hour ___min ___sec
Annunciation
enable
Enabled
Disabled
25 23
Annunciator
(1–8) location
01 - Annunciator 1
02 - Annunciator 2
03 - Annunciator 3
04 - Annunciator 4
05 - Annunciator 5
06 - Annunciator 6
07 - Annunciator 7
08 - Annunciator 8
PII - Pre-Ignition ILK
LCI - Load Control Input
ILK - Interlock
Annunciator
(1–8) short
name
Up to 3 characters
Annunciator
(1–8) name
Up to 20 characters
Table 60. Configurable Parameters. (Continued)
Parameter Comment
Table
#
Page
#