40 ScanPal EDA61K Mobile Computer
3. Center the aiming beam over the barcode. Make sure the entire barcode is
inside the illumination frame.
4. Release the Scan button when the computer beeps, and the Scan Status LED
briefly turns on. The barcode information is entered into the application in use.
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
About Scanning Configuration Barcodes
After completing the out-of-box set up process, Provisioning mode is
automatically turned Off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you turn On
(enable) Provisioning mode in the Settings app.
To learn more About Provisioning Mode see page 69.
Use the Scan Demo App
Use the Scan Demo app to read barcodes or to test your symbology decode settings.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Demos.
3. Swipe left or right on the screen until Scan Demo appears under the turntable.
Tap the center of the box image to open the app.
4. Point the scanner window at the barcode.
5. Press and hold any Scan button (i.e., right, left, or front) or tap and hold the on-
screen Scan button.
To Next Page
Loading...
Need help?
General
