Honeywell Silent knight 5895XL - Setting Device ID

5895XL Manual - P/N 151142-L8:L 08/09/2017 21
Connecting SBUS Modules to the 5895XL Hardware Installation
3.3.1 Setting the Device ID
board to set the module ID#. Figure 2.3 shows the location of the DIP switch on the board.
Figure 3.9 Possible Module Addresses
3.4 Connecting SBUS Modules to the 5895XL
1. Connect SBUS modules to the 5895XL as shown in Figure 3.10 or Figure 3.11.
2. All SBUS modules must have an ID. Use the DIP switches on the module board to assign an ID number (1-31) to the module. This
number identifies the module to the 5895XL and must be unique.