Honeywell SILENT KNIGHT Farenhyt Series - Connecting SBUS Modules to the RPS-1000

Model RPS-1000 Installation Manual 151153
3-5
3.4 Connecting SBUS Modules to the RPS-1000
1. Connect SBUS modules to the RPS-1000 as shown in Figure 3-6 or Figure 3-7.
2. All SBUS modules must have an ID. Use the DIP switches on the module board to assign
an ID number (1-31) to the module. This number identifies the module to the RPS-1000
and must be unique.
3. Software configuration steps vary for each SBUS module. For more information, refer to
the IFP-1000 Installation Manual (PN 151139) or IFP-1000ECS Installation manual (PN
151460) in the section that discusses the type of module you are installing.
Figure 3-6 SBUS Class A Connection to RPS-1000