-Full: No changes are allowed
When SCREEN LOCK is active, a “lock” icon will be displayed on the thermostat display
Locking the thermostat:
Touch MENU. Touch the > arrow until SCREEN LOCK appears. Touch SELECT.
Touch the < and > arrows until the desired lock setting is displayed. Touch SELECT
A pin will be displayed. Record this 4-digit code for your records. Press SELECT
Confirm or dismiss the change by touching YES or NO
Unlocking the thermostat:
Touch the “lock” icon.
Enter the pin by touching the +/- icons. Touch SELECT after each digit is entered to advance to the next digit.
After touching SELECT once the last digit is entered, the thermostat will return to the main screen in the Unlocked
state.
Locating my pin:
The screen lock pin is not adjustable on any Honeywell thermostat. To obtain the pin, remove the thermostat
faceplate by pulling it gently away from the wall plate. On the label on the back of the thermostat face-plate, locate
the DATE CODE. (4-digit number located on the right side of the label)
The pin is calculated by adding 1234 to the date code. (For example: A date code of 1644 would have a pin of 2878)
Screen Brightness:
The thermostat has an adjustable inactive screen brightness. This allows the user to dim the screen to their desired
preference. (When actively using the thermostat display [i.e. – touching buttons / making changes] the thermostat
screen defaults to full brightness. This feature is not adjustable.)
Adjusting Screen Brightness:
Touch MENU. Touch the > arrow until BRIGHTNESS appears. Touch SELECT.
Use the +/- icons to increase or decrease the brightness (1-5). Press DONE when complete.
Recovery: (also referred to as Smart Recovery, Smart Start, and Adaptive Intelligent Recovery)
The thermostat has the option to begin your schedule setting changes early in order to reach your desired
temperature at the start of the schedule period. When active, the thermostat “learns” how long it takes to reach
setpoint within your home, and starts heating or cooling early. (ex. My home is 65° at night, but set to 70° at 7:00a.m.
Rather than waiting until 7:00a.m. to start warming up, Recovery begins Heating the home early [based on its
algorithm and learned behavior] and starts heating the home at 6:00a.m., reaching the 70° setting by 7:00a.m.) When
active, RECOVERY is displayed on the thermostat screen in the top right corner.
Turning Recovery On / Off:
Touch MENU. Touch the > arrow until RECOVERY appears. Touch SELECT.
Touch the < or > icons to enable or disable RECOVERY. Press DONE when complete
Clock:
When connected to Wi-Fi, the thermostat displays the local time based on the account creators Zip Code (as related
to Time Zone). When not connected to Wi-Fi, the clock can be configured on the thermostat display. 12hr or 24hr
time displays are optional, as is Daylight savings time (DST)
Clean Screen:
To Next Page
Need help?
General
