EasyManuals Logo

Honeywell T6 Pro Hydronic Installation Instructions

Honeywell T6 Pro Hydronic
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
Installer system test
To perform a System Test:
1 Press and hold CENTER and buttons for
approximately 3 seconds to enter advanced
menu.
2 Use to go to TEST. Press Select to enter
System Test.
3 Use to change between Heat or Ver
(thermostat version information). Press Select.
4 Press to turn heat on. Press to turn heat
off.
5 Use the Home button to exit the System Test.
Number Alert/Reminder Definition
170 Internal Memory Error The memory of the thermostat has encountered an error. Please contact dealer for
assistance.
171 Set the Date and Time Set the date and time on your thermostat. The date and time are required for certain
features to operate, like the program schedule.
173 Thermostat Temperature
Sensor Error
The sensor of the thermostat has encountered an error. Please contact dealer to replace
the Thermostat.
177 Indoor Temperature Sensor
Error
Wired indoor temperature sensor is not connected or there is a wiring short. Please
contact dealer for assistance.
252 AC Power Lost No AC power detected. Please check the AC circuit breaker.
405 Battery Low Battery low. Please turn the system mode to off and replace the batteries.
407 Battery Critical Battery critical. Thermostat cannot control your system. Please replace the batteries
immediately.
514 Floor Temperature Sensor
Failure
Wired floor temperature sensor is not connected or there is a wiring short. When
the thermostat has been configured for AF mode, the thermostat will still control
the ambient air temperature but will ignore the floor temperature limits. When the
thermostat has been configured to F mode, heating will stop. However, when the air
temperature drops to, or below freeze protection temperature limit, heating will be
activated and control the ambient air temperature.
535 High Floor Temperature The measured temperature is above maximum floor temperature limit.
536 Freeze Protection The measured temperature is below freeze protection temperature limit.
Active alerts are displayed via the alert symbol and alert number in the clock
area on the home screen. You can read more information about active alerts,
snooze or dismiss non-critical alerts in MENU/ALRT.
Alerts

Other manuals for Honeywell T6 Pro Hydronic

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell T6 Pro Hydronic and is the answer not in the manual?

Honeywell T6 Pro Hydronic Specifications

General IconGeneral
BrandHoneywell
ModelT6 Pro Hydronic
CategoryThermostat
LanguageEnglish

Related product manuals