Honeywell T7300D User Manual

T7200D,E, T7300D,E,F AND Q7300 SERIES 2000 PROGRAMMABLE COMMERCIAL THERMOSTATS AND SUBBASES
63-4355—235
POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED.
USE ECONOMIZER INSTRUCTIONS FOR INSTALLATION DIRECTIONS.
USE A1 AND A2 WHEN THE CONTACT SHOULD BE NORMALLY CLOSED IN OCCUPIED MODE.
CONNECT GND TO EARTH GROUND.
INSTALL FIELD JUMPER BETWEEN X4 AND X TO POWER LEDS FROM SYSTEM TRANSFORMER.
DISCHARGE AIR SENSOR IS ONLY COMPATIBLE WITH T7300F THERMOSTAT.
1
1
4
2
M4946B
2
3
4
5
6
6
5
3
W2
L1
(HOT)
L2
Y1 O G
SUBBASE
X
EM. HT.
RELAY
R
C1 T
T7147 REMOTE COMFORT ADJUST MODULE
GND
B
C2
COMPRESSOR
CONTACTOR 1
C4 C3C5
CA1
T
CA2
CA4 CA3CA5
T
T
TRANSFORMER
E
HEAT
RELAY 2
HEAT
CHANGEOVER
VALVE
X3 X1X4
EQUIPMENT
MONITOR 2
EQUIPMENT
MONITOR 1
FAN
RELAY
COOL
CHANGEOVER
VALVE
A2A1
AS AS
DISCHARGE
AIR
SENSOR
ECONOMIZER
Fig. 23. Typical hookup of T7300E,F/Q7300C2004 in two-stage heat and one-stage cool heat pump system.
POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED.
USE ECONOMIZER INSTRUCTIONS FOR INSTALLATION INSTRUCTIONS.
USE A1 AND A2 WHEN THE CONTACTS ARE NORMALLY CLOSE IN OCCUPIED MODE.
CONNECT GND TO EARTH GROUND.
INSTALL FIELD JUMPER BETWEEN X4 AND X POWER LEDS FROM SYSTEM TRANSFORMER.
DISCHARGE AIR SENSOR IS ONLY COMPATIBLE WITH T7300F THERMOSTAT.
1
1
4
M4947B
2
3
4
5
6
6
5
2
3
W1
L1
(HOT)
L2
Y1 O G
SUBBASE
X
EM. HT.
RELAY
R
C1 T
T7147 REMOTE COMFORT ADJUST MODULE
GND
B
C2
COMPRESSOR
CONTACTOR 1
C4 C3C5
CA1
T
CA2
CA4 CA3CA5
T
T
TRANSFORMER
E
AUX.
HEAT
HEAT
CHANGEOVER
VALVE
X3 X1X4
EQUIPMENT
MONITOR 2
EQUIPMENT
MONITOR 1
FAN
RELAY
COOL
CHANGEOVER
VALVE
A2A1
AS AS
DISCHARGE
AIR
SENSOR
Y2
COMPRESSOR
CONTACTOR 2
ECONOMIZER
Fig. 24. Typical hookup of T7300E,F/Q7300C2012 in three-stage heat and two-stage cool heat pump system.

Honeywell T7300D Specifications

General

Brand	Honeywell
Model	T7300D
Category	Thermostat
Language	English