8 63-2604
Setting Schedule Times
Use the keys in the “Schedule” area of the
keypad for this procedure.
1. Press Occupied.
NOTE: Anytime a start time is not
required, press Clear Start Time.
2. Press Day until desired day is displayed.
3. Press Occupied or Not Occupied until the
proper period is displayed.
4. Press up ▲ or down ▼ until the
desired start time is displayed.
5. Repeat steps 3 and 4 for a given day.
6. Repeat steps 2 through 5 until finished.
Copying a Day
Use the keys in the “Schedule” area of the
keypad for this procedure.
NOTE: The thermostat must be in program
mode to use the copy feature. If the
thermostat is already in program
mode, skip step 1.
1. Press Occupied.
2. Press Day to select the day to be copied.
3. Press Copy.
4. Press Copy again.
5. Press Day until the day to receive the
copy is displayed.
6. Press Copy.
NOTE: DONE displays for two seconds
then the program display
reappears.
7. Repeat steps 2 through 6 for all the days
desired.
8. Press Run Schedule.
To Next Page
Loading...
Need help?
General
