9 63-2606
How do I return to the Application Opening
Screen?
Use the following command sequence: tap the title
tab, Set, Home. Note: All opening screen functions
are available through the Novice or Advanced
screen navigation.
How do I upload a thermostat configuration into an
existing config file name?
Use the following procedure to save an upload over
top of an existing configuration:
1. Upload the configuration from the T7350.
2. Delete the existing file using: File, Delete.
3. Save the upload data using: SaveAs.
How do I connect the PDA Configuration Tool to
the T7350 Thermostat?
Use the Honeywell TIM (part no.: 50000083-001) to
facilitate the connection between the PDA serial
cable DB9 (not included) and the T7350 RJ Jack.
How do I copy/modify an existing configuration
file?
Use the following procedure:
1. Load the existing configuration: File, Open,
[existing configuration name].
2. Save file under new name: SaveAs, [enter new
name], SaveAs.
3. Make appropriate configuration changes.
4. Save the new file: File, Save.
How do I exit the output manual override mode?
While in manual override mode, the lower left corner of
the PDA screen displays “Manual Override”. Tap
anywhere on the screen and the override mode is
deactivated in 60 seconds.
To Next Page
Loading...
Need help?
General
