Honeywell T7351 User Manual (English)

Other manuals for Honeywell T7351

Installation Instructions12 pages

Product Data20 pages

User Manual12 pages

Information4 pages

Questions and Answers:

J
Jackie TrujilloJul 26, 2025
Why is my Honeywell T7351 Thermostat display not working?
- W
  William WilsonJul 26, 2025
  If the Honeywell Thermostat display is not working, it may not be getting power. Ensure the X terminal is connected to the system transformer. Also, check for 24 Vac between the X and RH or RC terminals. If 24 Vac is missing: * Check if the circuit breaker is tripped and reset it if needed. * Check if the system fuse is blown and replace it if necessary. * Ensure the HVAC equipment power switch is in the On position. * Inspect the wiring between the thermostat and HVAC equipment, replacing broken wires and tightening loose connections. If 24 Vac is present, continue troubleshooting.
N
njonesAug 10, 2025
Why won't my Honeywell T7351 Thermostat temperature settings change?
- C
  Christopher DavisAug 10, 2025
  If you cannot change the temperature settings on your Honeywell Thermostat, it could be due to several reasons. The upper or lower temperature limits may have been reached. Check the temperature setpoints: Heating limits are 40° to 90° F (4° to 32° C), and cooling limits are 45° to 99° F (7° to 37° C). Another possibility is that occupied setpoint temperature range stops were configured; check setpoint stops and reconfigure if necessary. Finally, the keypad might be locked; if LOCKED appears momentarily on the LCD when a key is pressed, change the keypad lock level.
A
Ashley HillAug 15, 2025
What to do if Honeywell Thermostat temperature display is wrong?
- G
  Gerald JohnsonAug 15, 2025
  If the temperature display is incorrect, it could be due to a few reasons. First, the thermostat might be configured for the wrong temperature display (°F or °C). Press both the Run Schedule and Copy buttons, then reconfigure the display. Another reason could be a bad thermostat location, so consider relocating the thermostat. If the display shows three dashes and a degree sign (with all systems shut down), the T7351 is set for remote sensing, and the sensor is either missing, or the circuit is open or shorted.
E
edward84Aug 20, 2025
What to do if there is no warm or cool air from Honeywell Thermostat?
- J
  Jeremy BenderAug 20, 2025
  If the system indicator is displayed but no warm or cool air is coming from the registers, the call for heat or cool might not be fully activated yet. Check if any stage indicators (dots next to the system indicator) are displayed. If there are no stage indicators, no call for cool/heat via relay has been given yet. If you have conventional heating equipment, it might turn the fan on only after the furnace has warmed up; wait one minute after seeing the on indicator, then check the registers. Lastly, verify the operation of your heating or cooling equipment in Test Mode to ensure it is functioning correctly.