Honeywell T7351 - Changing Temperature Setpoint Until Next Program Period

Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
yourhome.honeywell.com
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
63-2652—01 K.K. Rev. 05-10
Printed in U.S.A.
NOTE: The default temperature setting
is the Not Occupied setpoint.
3. Press to display the default setpoint.
NOTE: The only way to change this
setpoint is to change the Not
Occupied setpoint.
Changing Temperature
Setpoint Until Next Program
Period
1. Press up S or down T until the desired
temperature is displayed.
2. The temporary temperature appears for
approximately ten seconds, then the
room temperature is displayed.
63-2652_A.fm Page 12 Monday, May 10, 2010 4:21 PM