EasyManua.ls Logo

Honeywell T8611 - Troubleshooting Common Thermostat Issues; Display and Programming Errors; Program and Time-Related Problems; Heating and Cooling System Malfunctions

Honeywell T8611
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IF. .
Display will not come on.
THEN. .
n
Check that heat or cool system power is on. If you use batteries,
replace with fresh ones.
n
Make sure thermostat is correctly mounted on subbase.
Display
flashes during programming.
n
YOU have reached the temperature setting limit. The setting range is
45’F to 88°F. In models with automatic heat-cool changeover, the
COOL temperature setting must be at least 3°F above the HEAT
temperature setting.
Display flashes during operation.
Program is lost due
to power outage.
Temperature change occurs
at the wrong times.
Heating will not come on.
n
Programming has been lost because ofa power outage. You must
reprogram.
. Check that backup batteries are installed correctly. Replace if
necessary. Reprogram the thermostat.
m Check the program times for the period in question. Be sure that
AM and PM indications are correct. Make sure the current day and
time are correct. Reprogram if necessary
n
Remember that the heating system or cooling system comes
on
before the WAKE and RETURN start times so the house will be at
the desired temperature when the period starts.
n
Checkthefuseorcircuitbreakerand replaceorresetifnecessary.
n
Check that switch on thermostat is set to HEAT or AUTO.
33
. The:thermostat has a built-in time delay, which may add to time
delays in th&cooling e$juipment. Allow up to 10 minutes after
changing the setting before the compressor starts.
n
,If temp@ure setti@is’lower than current:temperature, and dis-
,,play $8)~ COOL ON
qi
SYSTEM Iight’iS on, contact your heating
and air conditioning contractor.
The building is too
n
Press ~PRESENT SETTIN& to check, the current temperature
warm or too cool.
setting.
. If desired, change the time or tem@rature setting. See page 19.
Display says HEAT ON or system
. Allbwiime forthe heating equipmentto heat up before checking for
light is on, but no,heat is coming
heat at the register. ,,~
from the registers.
Display tlsshes,REPL~~A~, or goes
blank,when @tier:& turned
o!.
‘:
~,~,~~stalJ, fresh A&:alk$ne ,t+tteries (Seem page ,271.
,,: ,,,,, ‘,,:,~,,~ ~,
34

Related product manuals