Honeywell TH4000 Series - Temperature Override and Advanced Features; Temporary Program Schedule Override; Permanent Program Schedule Override (Hold)

Note: Make sure the thermostat is set to the system you want to program (Heat or Cool). Note: To cancel an unwanted
time period (except Wake), press and hold s + HOLD for 4 seconds while n the Set Schedule mode.
Program schedule override (temporary)
Note: Make sure the thermostat is set to the system you want to control (heat or cool).
Press or to immediately adjust the temperature. This will temporarily override the temperature setting for the
current time period.
The new temperature will be maintained only until the next programmed time period begins (see page 9). For example, if
you want to turn up the heat early in the morning, it will automatically be lowered later, when you leave for the day. To
cancel the temporary setting at any time, press RUN. Press HOLD to permanently adjust
Program schedule override (permanent)