Wire the thermostat IAQ relay to the low speed fan for dehumidification control at the equipment. The thermostat relay can be set to normally open or normally closed in the
thermostat installer setup.
Connecting to Wi-Fi
After installer setup, you will be prompted to connect to a Wi-Fi network.
NOTE: If you select No, the homeowner can connect to the Wi-Fi network later. (See “Connecting to Wi-Fi later” on page 9 or in the User’s Guide.) The thermostat will display its Home
screen and thermostat setup is complete.
1. Connect to the Wi-Fi network now.
1.1 Press Yes.
The thermostat will scan for available Wi-Fi networks.1.2 Use the arrow buttons to scroll up/ down or left/right. Press the Wi-Fi network name, then press Select.
NOTE: If the Wi-Fi network name is hidden, see “Connecting to a hidden Wi-Fi network” on page 10.1.3 When prompted, press the screen to edit the password (if necessary).
Enter the password. Press the or buttons to change the letter or number.
Press the button to move to the next character, or the button to move to the previous character.
Use the or buttons at the bottom to change letter case. Press Done when complete.
1.4 The screen will let you know when the connection is successful. Press Done when the connection is successful. If the connection is not successful, the screen will explain why
not. See “Unsuccessful connection” on page 9. Follow instructions on the screen to try again.
To Next Page
Loading...
