1 - 1
1
Getting Started
About This Manual
This User’s Guide provides installation and programming instructions for the
Voyager™ 1400g area-imaging scanner. Product specifications, dimensions,
warranty, and customer support information are also included.
Note: The selections in this User’s Guide are dependent on the Voyager 1400g
model you have purchased.
PDF bar codes can only be read by models 1400gPDF or 1400g2D and
cannot be read by model 1400g1D.
2 dimensional bar codes can only be read by model 1400g2D and cannot
be read by models 1400gPDF or 1400g1D.
Honeywell bar code scanners are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide.
An asterisk (*) next to an option indicates the default setting.
Unpacking Your Device
After you open the shipping carton containing the product, take the following
steps:
• Check for damage during shipment. Report damage immediately to the
carrier who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.
Connecting the Device
Connecting with USB
A scanner can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the device first, then to the
computer.
To Next Page
Loading...
