4 Xenon XP User Guide
Connect with Keyboard Wedge
A scanner or cordless base can be connected between the keyboard and PC as a
“keyboard wedge,” where the scanner provides data output that is similar to
keyboard entries. The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the termi-
nal/computer.
2. Connect the appropriate interface cable to the device and to the terminal/
computer.
Note: The power supply must be ordered separately, if needed.
3. If you are connecting a CCB01-010BT/CCB01-010BT-BF or CCB-H-010BT/
CCB-H-010BT-BF base horizontally, make sure the cables are secured in the
wireways in the bottom of the cordless base and the base sits flat on a
horizontal surface.
If you are connecting a CCB-H-010BT/CCB-H-010BT-BF
Base vertically, see Mount a CCB-H-010BT/CCB-H-010BT-BF Charge Base on
page 10.
Corded Xenon XP Scanner Keyboard Wedge Connection:
To Next Page
Loading...
