Unlinking the
11
If the base has a scanner linked to it, that scanner must be
unlinked before a new scanner can be linked. Once the previous
scanner is unlinked, it will no longer communicate with the
base. Scan the
Unlink Scanner
bar code to unlink a
scanner.
Trigge
r
Unlink Scanner
The following bar codes will allow you to use the scanner in
Manual Trigger - Normal Mode
(need to press the
trigger to
read) or
Presentation mode
(the scanner is
activated when it “sees” a bar code).
Note:
Presentation Mode continuously draws power, so use of
the external power supply is recommended for this mode.
Manual Trigger - Normal
(Default)
Presentation Mode
To Next Page
Loading...
