8.
Assembly
WARNING! The cleaner should be switched off and disconnected from the mains
power supply before assembling.
Note: Remove the protective film from the top cover.
Battery Replacement & Instalment
1. Release the battery cover screw
with a screwdriver, by turning in an
anti-clockwise direction. Open its
base plate.
2. Connect two terminals during
battery installation.
3. Place the battery into the cleaner
with the two strips face to the top.
Note: Ensure the terminals
are fully clipped in as shown on
the diagram.
4. Charge the battery 12 hours at first use.
IMPORTANT!
1. Remove the battery if the machine is being disposed of.
2. Power off first, before removing the battery.
3. Don’t store or use battery at any environment over 45ºC or in water.
4. Don’t apply external load to the battery or drop from height.
5. The battery must be recycled for safe treatment. Don’t discard it freely or throw it into fire
for fear of explosion.
6. In case of leakage, don’t expose liquid to skin or clothes, immediately wipe with a dry cloth and
send to recycling station or appointed maintenance outlet.
7. No chargeable battery from different suppliers can be used with machine.
8. To extend battery life, make sure to charge the battery 12 hours at first use of the robot or if it has
not been used for an extended period, otherwise its working time would decrease dramatically, far
less than its normal working time.
Note: The battery is guaranteed for a period of 6 months if they are maintained and operated
according to the Instruction Manual.
To Next Page
Loading...
Need help?
General
