10.
Preparation (continued)
Function Information on Panel
Power Indicator:
• When switched on, all lights remain on.
• When cleaning, the key you pressed will be on, and decorative
lights flash one by one.
• When recharging, the middle decorative light flashes.
• When recharging is complete, the middle decorative light will
stop flashing and remain on.
• When the battery is low, the charging light will be on and the
decorative lights will flash one by one.
AUTO:
• Press the “AUTO” button, the cleaner will be in automatic cleaning mode, if the battery is low,
the cleaner will search for the charging base plate to charge automatically.
• Press any button on front panel, the cleaner will stop cleaning.
• Ensure there are no obstructions, and remove all barriers especially any wires or ropes.
• In the case of low battery during cleaning, the cleaner will stop cleaning and with the sound like “D”
repeats ten times, then the charging light will illuminate and the decorative light will flash, one by one,
at the same time the cleaner will search for the charging base plate to charge automatically.
CHARGE:
• Press the “CHARGE” button, the cleaner will search the charging base plate to charge automatically,
press any button on panel, the cleaner will stop.
7. To obtain a better cleaning result, it is suggested remove any chairs from the area to be cleaned.
8. Make sure there is no step more than 20mm in the area to be cleaned, the cleaner may not be able
to go across or may get stuck.
9. Remove all easily damaged objects (including luminous objects, fabrics, glass bottles, etc.) before
using, or it may cause damage to these objects or affect the use of the cleaner.
10. Don’t leave movable threads, wire and other objects with the length of more than 150mm on the
ground or the brush may be entangled.
To Next Page
Loading...
Need help?
General
