Preparation
9.
Preparation
Battery Replacement and Instalment – Virtual Wall
Battery Replacement and Instalment – Remote Control
1. Open the cover.
2. Place the batteries, 2 x AAA DC 1.5V battery
(not included) with correct polarity (+/-).
3. Remove the battery if the Virtual Wall is not in
use for extended periods.
1. Open the battery cover and insert
the battery, 2 x AA DC 1.5V battery
(not included).
2. Place the positive and negative
poles correctly.
3. Remove the battery if the remote
controller is not in use for
extended periods.
Before Use
1. Before activating the cleaner, make sure the dust bin is empty and assembled properly.
2. Remove any object from the area to be cleaned in advance.
3. Make sure the area to be cleaned is not wet.
4. For carpets with tassels, fold the tassels under the carpet.
5. Close the door to prevent the cleaner running to the outdoor area.
6. When installing the charging base plate, do not leave the power cord exposed
on the floor, wrap the power cord on the back of the station.
To Next Page
Loading...
Need help?
General
