EasyManua.ls Logo

Hoover HWB 814 DN - Page 43

Hoover HWB 814 DN
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DE
LEUCHTANZEIGE TÜR
GESCHLOSSEN
Die Anzeige leuchtet,wenn die
Tür korrekt geschlossen ist und
das Gerät eingeschaltet ist.
Nach Drücken der Taste
START/PAUSE blinkt die Taste
zuerst, dann leuchtet sie
permanent bis zum
Programmende.
Wenn das Bullauge nicht korrekt
geschlossen wurde, blinkt die
Leuchtanzeige weiter.
Eine spezielle
Sicherheitsvorrichtung
verhindert,dass das Bullauge
unmittelbar nach dem
Programmende geöffnet
werden kann.Warten Sie ca.2
Minuten,bis die Leuchtanzeige
ausgeht und schalten Sie dann
das Gerät durch Drehen des
Programmwahlschalters auf die
Position AUS ab.
DISPLAY “DIGIT”
Die Anzeigen im Display geben
Ihnen ständig Auskunft über die
gerade durchgeführten
Funktionen des Gerätes.
1) WASCHTEMPERATUR
Wenn ein Programm
ausgewählt wird,erscheint
automatisch die empfohlene
Waschtemperatur durch
Aufleuchten der
entsprechenden Anzeige.
Falls eine andere Temperatur
durch Drücken der hierfür
vorgesehenen Taste eingestellt
worden ist, leuchtet die
entsprechende Anzeige auf.
2) TÜRVERRIEGELUNGSANZEIGE
Nachdem die Taste
START/PAUSE gedrückt wurde,
blinkt die Anzeige zuerst eine
Zeitlang, dann leuchtet sie
permanent bis zum
Programmende.
2 Minuten nach
Programmende erlischt die
Lampe, um anzuzeigen, dass
die Tür nun entriegelt ist und
geöffnet werden kann.
DOOR LOCKED INDICATOR
The “Door Locked” indicator
light is illuminated when the
door is fully closed and the
machine is ON.
When START is pressed on the
machine with the door
closed the indicator will flash
momentarily and then
illuminate.
If the door is not closed the
indicator will continue to
flash.
A special safety device
prevents the door from being
opened immediately after
the end of the cycle.Wait for
2 minutes after the wash
cycle has finished and the
Door Locked light has gone
out before opening the door.
At the end of cycle turn the
programme selector to OFF .
“DIGITAL DISPLAY
The display’s indicator system
allows you to be constantly
informed about the status of
the machine:
1) WASH TEMPERATURE
When a programme is
selected the relevant
indicator will light up to show
the recommended wash
temperature.The Temperature
button can be used to
decrease or increase the
temperature of your chosen
wash cycle. Each time the
button is pressed, the new
temperature level is shown on
the Wash Temperature
Indicator.
2) DOOR LIGHT
Once the START/PAUSE button
has been pressed the light
first flashes then stops flashing
and remains on until the end
of the wash.
2 minutes after the end of the
wash the light goes off to
show that the door can now
be opened.
EN
INDICADOR DE FECHO DE
PORTA
O indicador luminoso de
“fecho de porta” acende
quando a porta está
totalmente fechada e a
máquina está pronta para
começar.
Quando o botão de “INÍCIO”
é pressionado com a porta
da máquina fechada, o
indicador luminoso piscará
momentâneamente e depois
ficará ligado.
Se a porta não estiver
fechada, o indicador
luminoso continuará a piscar.
Um dispositivo especial de
segurança previne que a
porta abra de imediato ao
fim do ciclo de lavagem.
Espere 2 minutos depois do
ciclo de lavagem ter
terminado, e a luz de fecho
de porta desligar-se-á antes
da porta se abrir. No fim do
ciclo de lavagem,rode o
selector de programas para
a posição “OFF”.
VISOR “DIGITAL
O sistema de transmissão de
informações do visor permite-lhe
manter-se constantemente
informado sobre o estado da
máquina:
1) TEMPERATURA DE LAVAGEM
Quando é seleccionado um
programa,o indicador luminoso
relevante acende-se,para indicar
a temperatura de lavagem
recomendada.
O utilizador pode seleccionar uma
temperatura diferente com o
botão de regulação da
temperatura; a temperatura assim
regulada é apresentada no visor.
2) INDICADOR LUMINOSO DA
PORTA
Depois de o botão “START/PAUSE”
(arranque/pausa) ser premido,o
indicador luminoso começa a
piscar; em seguida,pára de piscar,
mantendo-se aceso até ao fim do
ciclo de lavagem.
2 minutos depois do fim do ciclo
de lavagem o indicador luminoso
apaga-se para indicar que a porta
da máquina já pode ser aberta.
PT
MANIPULO PARA ABRIR
A PORTA
Para abrir a porta rodar o
manipulo como ilustrado na
fig.
ATENÇÃO:
UM DISPOSITIVO
DE SEGURANÇA
ESPECIAL IMPEDE
A ABERTURA
DA PORTA NO FIM DO
CICLO DE LAVAGEM.
UMA VEZ CONCLUÍDO
O CICLO DE
CENTRIFUGAÇÃO
DEVERÁ ESPERAR
2 MINUTOS PARA
PODER ABRIR
A PORTA.
HANDLE DOOR
To open the door turn the
handle in the manner
illustrated in fig.
IMPORTANT:
A SPECIAL SAFETY
DEVICE PREVENTS THE
DOOR FROM OPENING
AT THE END OF THE
WASH/SPIN CYCLE. AT
THE END OF THE SPIN
PHASE WAIT UP TO 2
MINUTES BEFORE
OPENING THE DOOR.
GRIFF TÜRÖFFNUNG
Um die Tür zu öffnen,
drücken Sie auf dem Griff,
wie in der Zeichnung
abgebildet.
ACHTUNG:
DIE SICHERHEITSTÜR-
VERRIEGELUNG
VERHINDERT DAS
SOFORTIGE ÖFFNEN
DES BULLAUGES NACH
BEENDIGUNG DES
WASCH-PROGRAMMS.
WARTEN SIE DAHER
NACH DEM LETZTEN
SCHLEUDERN CA. ZWEI
MINUTEN, BEVOR SIE DIE
TÜR ÖFFNEN.
43

Other manuals for Hoover HWB 814 DN

Related product manuals