EasyManua.ls Logo

Hoover Impulse - Vacuum Assembly Instructions; Connecting the Reach Wand and Handheld

Hoover Impulse
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Assembly
Push the Handheld down
onto the Reach Wand
until it clicks into place.
Push the Reach Wand down onto
the Powered Nozzle until it clicks
into place.
Before fi rst use be sure to
fully charge the battery.
TIP: Charging your IMPULSE
may
take up to 3-4 hours.
123
WARNING
To reduce the risk of personal injury
from moving parts, turn the power
switch to OFF and disconnect all
accessories before servicing.
IMPORTANT
This vacuum cleaner is not free
standing. In between uses or when
carrying out any maintenance always
lie fl at on the fl oor in a suitable location
so it does not become a trip hazard or
can be stepped on.
HARD
FLOOR
BOOST
MODE
IMPORTANT
Use only the charger supplied by the manufacturer to recharge.

Table of Contents

Related product manuals