9
How to Empty
4.3 Press dirt cup release
button (C) and pivot cup
out.
4.4 Hold dirt cup over trash
receptacle, push dirt cup
door release lever (D) to
open dirt cup door (E).
Close dirt cup door (E).
Press firmly to secure.
4.4
E
4.5
4.5 Place bottom of dirt cup into vacuum body first. Pivot dirt cup into vacuum body and press
firmly until it locks into place.
To maintain optimal performance, filters should be cleaned
at least every two months under normal use.
FILTERS: When to Clean
4.7
To reduce the risk of personal injury - Unplug before
cleaning or servicing. Do not use vacuum without dirt cup
or filters in place.
D
4.6
4.2 To maintain optimal performance, empty the dirt cup before the dirt cup reaches the max
line (B). Place the vacuum in the upright position before removing the dirt cup.
DIRT CUP: When to Empty
To reduce the risk of personal injury - Unplug before cleaning or servicing. Do not use
vacuum without dirt cup or filters in place.
Very fine materials, such as face powder or cornstarch, may seal the filter and cause a
reduction in performance. When using the vacuum for this type of dust, empty the cup and
clean the filters often.
4.2
B
Actual model may vary from images shown.
Remove dirt cup as described in Fig. 4.3.
4.6 Twist the dirt cup handle counterclockwise to open and
remove lid.
Rinsable Filter: How to Clean
WARNING
! !
WARNING
! !
4.3
C
4.7 Pull tab to remove rinsable filter.
Rinse with water for two minutes or until water runs clear.
Then squeeze out excess water. Allow 24 hours for filter to dry
completely.
Replace filter, tab side out.
IMPORTANT
Allow filter to dry completely before replacing. Dry filter on
edge so air circulates on both sides of filter. This may take
up to 24 hours.
When used and maintained
properly, your Rinsable
Filter should not need
replacement within the
warranty period. If desired,
additional filter is available
at Hoover.com or call
1-800-944-9200. Ask for
Hoover
®
Part No.
304087001.
What to Buy:
Rinsable Filter
4.8
4.8 Replace dirt cup lid and twist clockwise until locked in
position.
Replace dirt cup as described in Fig 4.5.