10
4.13 With fingers under filter door lip, pull filter frame (A)
out and away from vacuum body. Hold filter over a trash
receptacle and tap out dirt and debris.
4.14 Bottom filter (B) must be pushed back into place first.
4.15 Then push the upper handle in (C) until it clicks.
4.16 Filter diagram: (B) bottom filter. (C) upper handle.
C
B
DO NOT RINSE OR WASH THE FILTER
MADE WITH HEPA MEDIA.
IMPORTANT
Filter Made With HEPA Media: How to Clean
Actual model may vary from images shown.
Cyclonic Filter Assembly: How to Clean
Remove dirt cup and twist the dirt cup handle counterclockwise
to open and remove lid as described in 4.6.
4.9 Pull filter assembly (G) out of dirt cup and remove.
4.10 Dirt and debris can be cleaned from the filter assembly
with the adjustable dusting brush.
4.11 Place the filter assembly on the dirt cup. Line up tabs (H)
on lid with dirt cup body.
4.12 Replace dirt cup lid and twist clockwise until locked in
position.
Replace dirt cup as described in Fig 4.5.
To reduce the risk of personal injury - Unplug before
cleaning or servicing. Do not use vacuum without dirt
cup or filters in place.
Do not use vacuum without dirt cup or filters
in place.
4.9 4.10
G
4.11
H
4.12
4.144.13 4.15 4.16
WARNING
! !
To reduce the risk of personal injury - Unplug before
cleaning or servicing. Do not use vacuum without dirt cup
or filters in place.
WARNING
! !
Filter Made With HEPA Media
When used and maintained properly, your Filter should not need
replacement within the warranty period. If desired, additional filter is
available at Hoover.com or call 1-800-944-9200. Ask for Hoover
®
Part
No. 440005573.
IMPORTANT
Allow filter to dry completely before replacing. Dry filter on
edge so air circulates on both sides of filter. This may take
up to 24 hours.
When used and maintained
properly, your Rinsable
Filter should not need
replacement within the
warranty period. If desired,
additional filter is available
at Hoover.com or call
1-800-944-9200. Ask for
Hoover
®
Part No.
304087001.
What to Buy:
Rinsable Filter
4.8
4.8 Replace dirt cup lid and twist clockwise until locked in
position.
Replace dirt cup as described in Fig 4.5.
A CB
To Next Page
Loading...
Need help?
General
