CONTENTS
SECTIONS
1. Series 2000 slide operator quick start instructions………………….. H201C.1
2. C2150 initialization……………………………………………………… H201C.2
3. Adjusting parameters (Procedure for changing preset parameters).. H201C.3
4. Adjustable preset parameters (chart of adjustable ranges)…………. H201C.3
5. Actuation features………………………………………………………… H201C.4
6. Autolock set up and initialization……………………………………….. H201C.4
7. Setting lock parameters…………………………………………………. H201C.5
8. Lock error codes (Trouble shooting guide)…………………………… H201C.5
9. Autolock test points……………………………………………………… H201C.5
10. Autolock functions……………………………………………………….. H201C.5
11. Reed switch diagnostics………………………………………………… H201C6
WIRING DIAGRAMS
1. C2150 typical wiring for 2000 linear drive………………………………. H201C.7
2. Actuating and control switch connections………………………………. H201C.8
APPENDIX
A. In case of difficulty (Trouble shooting the C2150)…………………….. H201C.9
B1. Code displays (definitions and trouble shooting guide)…………….. H201C.10
B2. Code displays (definitions and trouble shooting guide)…………….. H201C.11
B3. Code displays (definitions and trouble shooting guide - short cuts).. H201C.12
C. Terminal CN2 (Description of terminal block connections) …………. H201C.13
D. Motor test………………………………………………………………….. H201C.13
GENERAL STATEMENT
The C2150 is a microprocessor that uses a series of inputs, outputs and custom software to control a slide door.
The inputs are usually supported by LEDs that lets the technician see what information is coming into the control
and the outputs are in the form of display codes, LEDs and actual control of the motor, autolocks etc. This manual
is written for the C2150 control with Version 1 software which is used in the controls of the 2000 series linear drive
operators. The C2150 control receives its power from a separate power supply (usually a C3955) which
provides +27 to +35 VDC to power all of the accessory devices as well as power for the control itself. The power
supply also delivers +100 to +120 VDC to the control which is reduced by a MOSFET (duty cycle control) and is
called into service at variable levels through software and parameter selection. It is our hope that this manual will
guide the experienced technician through the efficient and safe setup of the C2150 slide door control. Remember
that all installations must comply with ANSI 156.10.
To Next Page
Loading...
