Horton C2150 - Linear Drive Microswitch Diagnostics; Running Microswitch Diagnostic Test; Partial Open Switch Installation

DOWN
+100
Wht
Blk
Orn
Close check
Wire
retainer
Open check
Blu
Open cutoff
Brn
Close cutoff
Orn
Red
Wht
Brn
Grn
Yel
Blu
Blk
Grn
Yel
Red
-Move the door manually through the open and closed positions to verify that each code is present for the position listed.(See the chart below)
-A blank display means that the door is in mid-stroke (no switches are tripped).
-Missing codes, or codes that appear in improper order, indicate a problem with a switch assembly or a defective switch lace, or possibly the C2150.
R
C2045
MAGNET
-Full
OP
en
-O
pen
C
heck
Open Cycle
1.0010d 10/21/05
+100
R
+100
R
C2022
Harness
11. REED SWITCH DIAGNOSTICS
In software Version 1.00 or later, press the
RESET
& the
DOWN
button, release the
RESET
and hold the
DOWN
button until
the display shows ut
Running a Reed switch test
DOWN
UP
RESET
SET
C2045
Magnet
MOTOR END
The display will, briefly,
show ut (for Reed switch test)
Power up the control while
holding the DOWN button.
OR...
UP
H201C.6
To exit the reed switch test press
RESET
-F
ully
C
Losed
Close Cycle
-C
lose
C
heck
RESET
+100
R
R
+100
MOTOR END
C2045
MAGNET
SET
Secure all switch wiring
with wire retainers