Hotone AMPERO II Stomp User Manual

Then press the knob to confirm the selection:
• If the object selected is a button, it will respond as if you’d touched the button on the touchscreen.
• If the object selected is a parameter, you can use the main knob to adjust the parameter value. Pressing the main knob again
will take you back to selection mode.
Tools
In this section you’ll know how to:
• Use Ampero II Stomp’s tuner and looper
• Set a proper unit mode depending on your needs
• Bypass Ampero II Stomp like a pedal
Tuner
Hold footswitch 1 to open the tuner.
On the upper part is a scale that indicates your pitch. Left of center is flat, and right of center is sharp. As you tune your
instrument towards the middle, the color of the scale will change from red (out of tune) to yellow (near pitch) to green (in tune).
Quick access knob 1 adjusts the pitch calibration (REF PITCH), ranging from 415Hz to 475Hz. Standard pitch is set at 440Hz.
Quick access knob 3 lets you select the tuner mode:
• Thru (for effect signal through)
• Bypass (for dry signal thru)
• Mute (for silent tuning).
You can exit the tuner either by pressing any footswitch or by pressing the Back button on the touchscreen.
Please note:
The details of use and programming may slightly vary under certain operational circumstances. Please read this manual
carefully to get all the necessary information.
The gold square indicates the patch number is selected
Turn Main Knob to go through the patches
Exittuner
Pitchflat
Pitchsharp
Intune
Indicatesthecurrentnotename
Selectstunermode
Adjuststhepitchcalibration
Using the Interface
8
DES I GN IN S PIRATION

Hotone AMPERO II Stomp Specifications

General

Power Supply	9V DC
Type	Multi-effects Processor
Processor	Dual DSP
IR Loader	Yes
Looper	60 seconds
Connectivity	USB, Bluetooth, MIDI
I/O	Expression Pedal