1. Connecting your Device
Plug your guitar in to the Ampero II Stomp’s input jack and run a cable from OUTPUT L to your amp.
Please remember:
(1) Keep your amp and unit volume down.
(2) Connect your cable to the amp’s FX Loop Return if it has one (see Suggested Setups section on ).page 37
(3) When using with studio monitors, we suggest to use a stereo pair of monitors for best possible experience. Remember to
turn monitor power off or turn monitor volume down before connection to prevent from possible device damage/hearing
loss.
(4) When using with headphones, we suggest to use studio monitor headphones for best possible experience. Headphones
with built-in microphone are not recommended – the TRRS connector may not be correct recognized due to different
manufacturers, which may lead to malfunction.
2.Connect the power supply and turn ON.
3. Select GLOBAL to enter Global Menu, select I/O and find Input Mode. Select a correct input mode based on what kind of
instrument you have: E.GT for electric guitar or bass, A.GT for acoustic instruments, Line for keyboards. For stereo inputs, you
need to set both L/R inputs. The default is set to E.GT, which means, in most situations/scenarios, you don’t need to change it.
4. Tune your guitar. Press and hold footswitch 1 until the TUNER comes on the display screen (see Tuner section on ). page 8
Pluck each string and tune until the pitch reaches the middle of the screen and turns green, as below:
When finished, tap any footswitch to exit the tuner.
5.Select a patch:
•Tap footswitch 1, 2, or 3 to choose a patch you like.
•Tap footswitches 1 and 2 together to move backward through the banks. Tap footswitches 2 and 3 together to move forward
through the banks.
•In default settings, when switching banks, the unit will stay in the previous patch you’re using (called Wait Mode); you need
to tap one footswitch again to confirm patch selection.
Getting Started
Footswitch 1 Footswitch 2 Footswitch 3
5
DES I GN IN S PIRATION
To Next Page
Loading...
Need help?
General
