LOOPER
In default mode, pressing footswitch 3 and the CTRL footswitch together will open the looper menu.
The progress bar at the top will be shown in red during recording and
overdubbing. It will be shown in green in play mode.
Footswitch 1 controls half speed playback. Footswitch 2 controls
reverse playback. These footswitch controls correspond with the 1/2
SPD and REV buttons on the touchscreen.
When you record phrases with drum rhythms, you can sync drum
rhythms to your loop phrase by turning on drum sync switch. Please
note that some unusual operations (e.g. randomly play/stop
looping/drum machine or change drum style/tempo) may break the
sync status. Switching 1/2 SPD and REV on/off won't affect this.
You can use "Footswitch X" (X=1-4, corresponding to FS 1,2,3 and CTRL)
to assign function of footswitch in looper page. The function includes
the following:
Rec/Play: Tap to recording, then tap again to start playback
Drum Rec/Play: Start drum when starting to record
Stop/Clear: Tap to stop recording and hold to clear
Drum Stop/Clear: Stop drum when stop recording
FX: Tap to toggle 1/2 speed function. Hold to toggle reverse function.
(Violet LED on)
1/2 SPD: On (Yellow LED on)/Off (Yellow LED off)
REV: On (White LED on)/Off (White LED off)
Drum: On (Green LED on)/Off (Green LED off)
Looper Exit: Exit looper page
Operation
On with no data
Stop
Tap footswitch 3 when there’s no data
Tap footswitch 3 while recording, overdubbing, or paused
Tap footswitch 4 while loop is playing
Tap and hold CTRL footswitch
Each time a recorded loop plays from the beginning
Function/Status
Stop
Stop
Record
Play
Stop
Clear
Play
LED Color (FS 3)
None
Flashing green
Steady red
Steady green
Flashing green
Quickly flashing green
Single flash
LED Color (CTRL)
None
Flashing green
None
Steady Green
Flashing green
Quickly flashing green
Single flash
REC LEVEL adjusts the loop recording level from 0-99.
PRE/POST selects the position of looper in the effects chain.
• In Pre mode, the looper will record mono audio without any effects,
up to 100 seconds.
• In Post mode, the looper will record stereo audio with effects, up
to 50 seconds.
LOOP LEVEL adjusts the loop playback volume from 0-99.
Exit the looper by pressing BACK on the upper left of the screen.
DES I GN IN S PIRAT ION
Ampero Tools
Exit looper
Currentlooperstatus
1/2speed on/off switch
Reverseon/offswitch
Record/playtime
Clearallrecordeddata
Record/playprogressbar
Previouspatch
Nextpatch
Switcheslooperposition
(pre/posteffects)
ControlslooperplaybacklevelControlslooperrecording level
Default Looper operation and status modes:
6
Drum machine on/off switch
Drum sync on/off switch
Reminder:
1. When the loop recording reaches it’s time limit, the looper will
automatically stop the recording and begin playback.
2. When the looper is in Post mode, changing patches will not
change already recorded loop phrases.
3. Half-speed and Reverse functions will affect all recorded loop
phrases.
4. If the looper is switched to a different position while it’s running,
the loop will automatically stop and be erased.
To Next Page
Loading...
Need help?
Digital Audio Processing
