DESIG N IN SP IRATION
Edit
1. Adjust the parameters
Use the onboard knobs to adjust the effect parameters. The screen display will be shown as below when adjusting:
1 - Current parameter value you’re adjusting (shown: volume)
2 - Saved parameter value in the current patch (PREV. = Previous value)
The MIC POSITION X/Y controls the microphone horizontal/vertical position, set X=Y=0 to set the microphone on axis; Z controls
the distance between microphone and speaker cap.
The MIC TYPE lets you select a microphone type you like. Turn this knob to minimum to turn off microphone simulation.
x
y
0
z
x
0
To Next Page
Loading...
