13 of 36
Indesit Company
Service Manual UK English
AUTO-TEST
This helps with a quick check of the loads and sensors (thermistors), which otherwise are difficult to
activate. NOTE: - Before using the AUTO-TEST it is advisable to check the correct operation of the
Mains (Green), Super Cool and Super Freeze (Amber) LEDs and the fridge interior lamps, which are
used for signalling possible malfunctions. Ensure both the Super Cool and Super Freeze have not been
selected before starting the Auto-Test.
TO ACTIVATE TO DEACTIVATE CHECK RESPONSE
NO-FROST
MODELS
FF187E
&
FF200E
1. Open the fridge
door and keep
ajar while in
auto-test.
2. Turn the fridge
and freezer
control knobs to
the minimum
setting
(appliance OFF
position).
3. Push and hold
the Super
Freeze button in
until all three
LED lights
illuminate at the
same time.
(The LED lights
will extinguish
after 5
seconds.)
Automatically:
After 300 seconds
from start of the
Auto-Test it will be
deactivated.
Manually by:
Turning the fridge
and freezer control
knob from the OFF
position.
Or
Switching OFF the
power supply
First Stage:
Fridge baffle opens &
evaporator fan runs -
Check for baffle
operation, feel for
airflow at both fridge
and freezer vents.
Second Stage:
Heaters and Sensors
check -
Feel for warmer air
from freezer vents
during defrost heater
check.
Third Stage:
Fridge baffle closes -
Check for baffle motor
operation.
Finish of Auto Test:
Evaporator fan stops
and one beep sounds.
No Fault:
Super Cool &
Super Freeze
LEDs OFF
and
Power LED ON
Fault Detected:
Fridge interior
lamp flashes if
during the
checks
described a fault
is detected.
The console
LED lights will
determine the
actual fault
code.
Refer to the
Table on
page14.
To Next Page
Loading...
