HotSpring Aria Instructions

x Page x x Page 10 Pre-Delivery Instructions
SERVICES AVAILABLE FROM YOUR
HOT SPRING
SPA DEALER
Service Cost
Pre-Delivery site inspection _____________
Deliver spa to installation site _____________
Unwrap spa and haul away packaging material _____________
Set up & level spa _____________
Fill the spa with water _____________
Connect the spa to its power source (115 volt models) _____________
Explain and test the spa’s operation
• Jet system • Moto-Massage
®
jet • Comfort Control
®
system
• Set temperature control • Control panel functions
Explain the safety features
• GFCI • Heater high limit • Heater thermal cut-off
General spa operation & maintenance orientation _____________
Water quality and maintenance orientation _____________
Adjust the water’s Total Alkalinity, Calcium Hardness and pH _____________
Sanitize the water _____________
Inspect the spa cover, place on spa _____________
Review winterizing instructions _____________
Review Owner’s Manual & Warranty Card _____________
Follow-up call _____________
In-store spa water analysis _____________
In-store spa water analysis _____________
TOTAL COST _____________
Strip wire
insulation back
½”
Entire stripped
end of wire
must be inside
Terminal
Block
After step 6,
pull on wire to
ensure proper
installation
Remove
screwdriver
Install
Stripped end
of wire into
Terminal
Block
Push top of
screwdriver away
from wire
Terminal Block
Insert
screwdriver to
engage cage
clamp
4
6
1/2”
3
5
3
WIRE INSTALLATION
FOR CONTROL BOX TERMINAL BLOCK
(Layout of Spa’s Terminal Blocks may vary)
Wire Installation Steps
Refer to spa’s wiring
diagram on back of Control
Box Cover for proper wiring
andjumperconguration!

HotSpring Aria Specifications

General

Water Care System	FreshWater® Salt System
Lighting System	LED lighting
Control System	Wireless remote control
Heater	4, 000w/230v
Pump	2 pumps
Filtration	Tri-X filter
Warranty	5 years equipment
Seating Capacity	5-6