Page 11
Instructions for Use:
1. After filling your hot tub, use a test strip to measure the
hardness level of the water. If hardness is above 100 ppm,
use the VANISHING ACT calcium remover to soften the water.
Suggested Hardness Level: between 75 - 150 ppm, (it must
be between 25 - 75 ppm when using the FRESHWATER Salt
System in order to work).
2. Rinse the VANISHING ACT calcium remover with running water
until water runs clear. When placed in the hot tub, slight color
transfer to the water may occur and can be easily resolved with
chlorine.
3. Locate your heater return in footwell (see illustration above).
a. Place the VANISHING ACT calcium remover (flat side down)
over the heater return.
b. After 10-12 hours, flip the calcium remover over and
reposition over heater return.
c. After a total of 24 hours, take the calcium remover off of the
heater return and discard.
Note: DO NOT RUN JETS WHILE CALCIUM REMOVER IS IN
PLACE.
IMPORTANT:
• Always make sure water is balanced and properly sanitized,
using the EPA approved sanitizer, before entering your hot
tub.
• For maximum effectiveness, ensure that the calcium
remover remains on the suction fitting while the calcium
remover is in use.
• Calcium remover may not be necessary if water hardness is
already in or below the suggested range.
• Multiple calcium removers may be needed if initial water
hardness is above 200 ppm.
VANISHING ACT INSTRUCTIONS
HEATER RETURN
(Your spa may look different)
Water Quality and Maintenance
To Next Page
Loading...
Need help?
General