CHARGING YOUR ECLIPSE
CHARGING THE DEVICE
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging
indicator light ON THE CHARGER will be green.
• Connect the cable with the power supply (IOOV 240V; 50, 60 Hz).
• Align and connect the 3-pin charging cable into the charging port
of the Eclipse. DO NOT FORCE OR BEND THE CHARGING CABLE INTO
THE CHARGING PORT, AS IT MAY CAUSE THE PRONGS TO BEND OR
BREAK.
• Once attached to the board, the charging indicator light ON THE
CHARGER should change to RED, indicating that your device is now
being charged.
• When the RED indicator light on your charger turns to GREEN, then
your device is fully charged.
• A full charge may take up to 3.5 hours. While charging, you will see
a yellow flashing light on the scooter, which also indicates charging.
Do not charge for more than 5 hours.
• After fully charging your Eclipse, unplug the charger from your
device and from the power outlet.
BATTERY CARE / MAINTENANCE
BATTERY SPECIFICATIONS
Battery Type: Rechargeable lithium ion battery
Charge Time: Up to 3.5 hours
Voltage: 36V
Initial Capacity: 4.0 AH
BATTERY MAINTENANCE
The lithium-ion battery is built into the device. Do not disassemble the
device to remove the battery or attempt to separate it from the
device.
When charging the device, please use the enclosed 3-pin
charging cable or otherwise ensure that the battery charging
conditions are met.
• Do not connect or attach the device or the battery to a power
supply plug or directly to a car's cigarette lighter.
• Do not place the device or batteries near a fire, or into direct sunlight.
Heating the device and/or the battery can cause additional heating,
breaking, or ignition of the battery inside the device.
20
To Next Page
Loading...
