EasyManua.ls Logo

Hover-1 i-200 - Page 19

Hover-1 i-200
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY ALERTS
While riding your i-200, if there is a system error or improper operation
performed, the i-200 will prompt the User in a variety
of ways.
You will hear a beep sound alerting you to take precaution and
cease operation, which may make the device stop suddenly.
The following are common occurrences where you will hear the
Safety Alerts. These notices should not be ignored, but appropriate
action should be taken to correct any illegal operation, failure or
errors.
Unsafe riding surfaces (uneven, too steep, unsafe, etc.)
When you step on the i-200, if the platform is tilted more than 8
degrees forward or backward.
Battery voltage is too low.
The i-200 is still charging.
During operation, the platform self initiates to tilt due to excess
speed.
Overheating, or motor temperature is too high.
The i-200 has been rocking back and forth for over 30 seconds.
If the system enters protection mode, the alarm indicator will light
up and the board will vibrate. This typically occUs when the battery
is about to run out of power.
If the platform is tilted forward or backward more than 8 degrees,
your i-200 will power off and stop suddenly, possibly causing the rider
to lose balance or fall off.
If any or both tires are blocked, the i-200 will stop after 2 seconds.
When the battery level has depleted below protection mode, the
i-200 engine will power off and stop after 15 seconds.
While sustaining a high discharge current during use (such as

Related product manuals